Official PayPal Seal

  Home > Antennas >

  Poynting 4.9-6GHz 31dBi Grid
 
AT-30GR-58


 
Click Here for Data Sheet
Click Here for Install Instructions



List Price: $89.00
Our Price: $79.00


Stock Status:
In Stock


Availability: Usually Ships in 24 Hrs
Product Code: AT-30GR-58
Qty:

  
Description
 
Poynting 4.9 - 6GHz 31dBi Grid Antenna The 27"x35" grid reflector yields a 4.9 - 6.0 GHz grid with a gain of an impressive 31 dBi. This antenna is unique in its excellent performance at the high frequencies since the grid density was from the start optimised for use in this band. Many earlier competitors used 2.4 GHz reflectors which “leaks” considerable energy when used in the 5 GHz band. The new parabolic 27"x35" aluminium grid antennas are considerably lighter than our previous grid dishes. The design is such that the grid is moulded in two halves (split-design) which results in a 65% reduction in packaging volume. The feed design also optimises aperture efficiencies which gives significantly higher gain when compared to similar grid antennas.
Features
- UV Resistant powder coat finish
- Rugged outdoor construction
- Quick and easy installation
- Light weight and low wind resistance
- Azimuth and elevation continuous adjustment
Applications:
- Ultra-secure wireless LAN point-to-point communication
- Can be used as client antennas in a wireless network in the 4.9 – 6.0 GHz frequency band
- Long range CPE installation

Average Customer Review: Based on 1 reviewsWrite a review.

Suggested Accessories
MikroTik RB411AH
Our Price: $99.00
Add
RB-411AH
DBii F50 Pro
Our Price: $50.00
Add
MP-F50-PRO
1M NMale to NMale Cable
Our Price: $16.00
Add
PT-NMNM-1


  0 of 0 people found the following review helpful:
 
Feed horns out phase with the mount. October 24, 2011
Reviewer: Larry Malone from Buffalo, KY United States  
I got two of these where the feed horn and the end that attaches to the reflector were turned 90 degrees out.  That is, when you had the reflector set up for vertical, the feedhorn would be in the horizonal position or when the reflector was in the horz. position, the feedhorn would be in the vertical pos.  Factory assembler screwed up,  Remedy:  Factory replacement.  Or drill out two holes, opposite of the other two.  If you get properly assembled feedhorns,  Once the repaired was made.  Performance is excellent.

Was this review helpful to you?


Browse for more products in the same category as this item:

Antennas
Antennas > 5.1 - 5.8GHz
Antennas > 5.1 - 5.8GHz > Grid
Antennas > 5.1 - 5.8GHz > Directional
Antennas > 4.9GHz


MikroTik Level 4 WISP License $35.00
MikroTik RB411 Outdoor AP Kit $139.50
ALIX 256MB 1LAN 2mPCI 1USB $110.00
Ubiquiti NanoStation 5 MIMO $89.00
Compact Flash to IDE Converter $3.00
MMCX to NFemale Bulkhead Pigtail $10.00
Medium Plastic PCB Standoff Kit $2.50
Motorola CanopySM 900MHz $310.00
10Meter LMR400 Equiv NM to NM Cable $30.00